Metal & Lighting Integration
SPECIALIST SOLUTION

Metal & Lighting Integration

Architectural metalwork designed to hold light — backlit panels, illuminated sculptures and lit entrances, fabricated with the lighting interface built in.

Same project: surface & lighting

Unlit reflective surface
Unlit reflective surface
Blue LED outline lighting
Blue LED outline lighting

Both photographs show the Shentie TOD deer installation. Viewpoints and ambient light differ; these are not same-angle day/night photographs.

Architectural metalwork designed to hold light — backlit panels, illuminated sculptures and lit entrances, fabricated with the lighting interface built in.

We fabricate the metal body — panels, sculptures, entrances and walls — and build the lighting interface into it: mounting points, cable channels, access panels and base integration. Light sources, drivers and control systems are specified by your lighting consultant or supplied by a lighting partner; we coordinate the interface so the metalwork and the lighting arrive ready to connect on site.

The night effect is confirmed before production, not after. We build a lit sample or mock-up of the metal detail with the real light source, check it against day and night reference images, and agree the finish — brightness, spread, color — before the full run.

Large illuminated pieces are fabricated in numbered sections, trial-assembled in our factory and shipped ready for on-site assembly. Access panels and segmented joints keep light sources and drivers reachable — lamps can be replaced without dismantling the structure.

Applications

BacklightingInternal glowOutline lightingSpot accentsLED integration
Supply
Metal body: FSICD factory · Light source / drivers / control: by your lighting consultant or partner, coordinated with us
Lighting
LED modules per the lighting design, mounted to our fabricated interface
Power
Driver and control location agreed in design; concealed in base or access zones
Cabling
Cable channels formed in the metal; entry points and routes per layout
Base
Integrated plinth or base with equipment space where required
Maintenance
Access panels, segmented joints, replaceable light sources

How we work

01

Lighting layout agreed — positions, power and control confirmed with your lighting consultant or partner

02

Lit sample built — a mock-up of the metal detail with the actual light source in place

03

Day & night effect checked — confirmed against reference images or an on-site mock-up at dusk

04

Effect approved, production starts — numbered sections fabricated to the approved sample

Project specifications

Adjust any value to match your project — these are sent with your inquiry.

Discuss a Similar Project

Products in this service

Guides & articles