Complex Curved Metalwork
SPECIALIST SOLUTION

Complex Curved Metalwork

Double-curved panels, freeform sculptures and sculptural architectural features — from 3D model to numbered, trial-assembled finished pieces.

Double-curved panels, freeform sculptures and sculptural architectural features — from 3D model to numbered, trial-assembled finished pieces.

Double-curved and freeform geometry breaks every rule of flat fabrication. Each panel must be formed in two directions at once, the minimum radius is limited by the material and its thickness, and small flattening errors grow into visible mismatches at the seams. We solve these problems before cutting — not during installation.

We start from your 3D model. Our engineers check feasibility, flatten each surface, break the form into numbered segments with a cutting plan, and confirm minimum radius and tolerances against the actual material — so every segment is manufactured to fit its neighbour.

Segments are cut on CNC laser and formed by roll bending, stretch forming or press forming. Curved parts are joined on jigs, welded and ground until the seam disappears, then finished — mirror, hairline or PVD — after forming, so the surface stays consistent across the whole curve.

Every complex piece is trial-assembled in the factory, re-measured against the model and numbered for crating. Panels, sculptures and ceilings ship ready to install. Send your 3D model (STEP, IGS or similar) with material and finish preferences — we confirm feasibility and quote within 24 hours.

Applications

Double-curved facadesFreeform sculpturesCurved ceilings & soffitsFeature columnsStair & handrail structuresEntrance canopies
Material
304 · 316 stainless · aluminum
Thickness
1.0–3.0 mm panels · structural up to 30 mm
Panel size
Up to 6 m long in one piece
Radius
Project-specific — depends on material, thickness and forming method
Finish
Mirror · hairline · PVD, applied after forming
Engineering
3D model review · flattening · numbered breakdown
Assembly
Factory trial assembly & numbered packing
MOQ
1 piece (prototype) · by project

How we work

01

3D model review — feasibility, flattening and minimum-radius check against the material

02

Panel breakdown — numbered segments, cutting plan and tolerances

03

Cutting & forming — CNC laser cutting, roll / stretch / press forming

04

Welding & grinding — curves joined on jigs, seams finished invisible

05

Surface consistency — mirror, hairline or PVD applied across the curve

06

Trial assembly & QC — factory dry-fit, re-measured and numbered for crating

Project specifications

Adjust any value to match your project — these are sent with your inquiry.

Discuss a Similar Project

Products in this service

Guides & articles